Preparation
Order contains
Included is:
MonkeyMounts helmet mount
Cleaning cloth (70% alcohol)
Safety loop
MonkeyMount's business card
Step 1
Positioning
Before removing the backing film, place the helmet holder in the desired location to check the position.
This area is then thoroughly cleaned using the cleaning cloth .
Step 2
Fastening
Carefully remove the backing film of the 3M adhesive tape and do not touch it with your fingers.
The helmet holder is heated for 10-15 seconds (warm, not hot!) and pressed evenly onto the cleaned area for 1-2 minutes .
(For example, use a regular hair dryer. A heat gun or similar device generates too much heat and may damage the product.)
Step 3
Usage
First use only possible 24 hours after application so the 3M adhesive tape can ensure maximum hold.
Disclaimer:
If the installation is incorrect or the steps are not followed, the safety of your camera cannot be guaranteed.
The safety loops needs to be attached in all cases. No liability will be accepted if this is not done.
No pulling movements to the side.
For racing use only.